Description

The HT17X equipment consists of a heated water bath together with a set of instrumented shaped test pieces. Each of the shapes incorporates a thermocouple to measure the temperature at the centre of the shape.

A total of six shaped test pieces are provided, i.e. three simple shapes (a rectangular slab, a long solid cylinder and a solid sphere) each manufactured in two different materials (brass and stainless steel).

Measurements taken on a shape in one material can be used to confirm the conductivity of a similar shape constructed from a different material. Transient-temperature/heat-flow charts are supplied for each of the shapes.

A circulating pump mounted alongside the water bath draws water from the bath and returns it at the base of a vertical cylindrical duct, which is located inside the water bath at the centre. A holder ensures each of the shapes is quickly and correctly positioned within the vertical duct for measurements to be taken.

The upward flow of water at constant velocity passing the shape ensures the heat transfer characteristic remains constant and also ensures the water surrounding the shape remains at a constant temperature.

The rate of water recirculation can be varied by using the software to adjust the DC voltage on the pump or use PID controller to achieve flow-rate set-point automatically. The shape holder has been carefully designed to eliminate the need to touch the shape while its temperature stabilises in air, and also to position the shape accurately inside the water bath while transient measurements are taken.

A thermocouple mounted on the shape holder contacts the hot water at the same instant as the solid shape and provides an accurate datum for temperature/time measurements.

A thermostat allows the water to be heated to a predetermined temperature before taking measurements. The large volume of water in the bath ensures that any change in the temperature of the water, as the measurements are taken, is minimal.

The water bath is heated by a mains powered electrical heater, and protected by a residual current device for operator safety. A thermocouple located in the water bath enable the temperature of the water to be monitored and adjusted to the required temperature.

Experimental Capabilities

• To observe unsteady state conduction of heat to the centre of a solid shape, when a step change is applied to the temperature at the surface of the shape
• Using analytical transient-temperature/heat flow charts to determine the conductivity in cylinders with different conductivity
• Investigating the effect of shape, size and material properties on unsteady heat flow using analytical transient-temperature/heat flow charts